 |
 |
TABLE OF CONTENTS
Introduction
Telephone Interface
A ring cycle is simply the number of times a call will ring your phone. The standard ring cycle is approximately 4 rings. Your primary number will only ring for one ring cycle (about 4 rings). Both of your follow me numbers will ring for 2 ring cycles (with a break in between to give the caller the option to continue to hold or to press 2 and leave a message). At the end of the 2nd ring cycle, the caller will be asked to leave a message. However, both your follow me numbers will continue to ring for up to 3 minutes or until your caller disconnects.
|
TIP:
Go to LinxWeb and add important callers to your speed dial list - don't forget to record a name announcement for each number! They won't have to announce themselves and you will always know who is calling.
|
While on a call, you may press ### to place a caller on hold. Once the caller is on hold, you have the following options:
Press 1
|
Re-connect to caller
|
TIP:
Hear something that sounds like call waiting? Place your current call on hold (###) and then press # again to listen to a name announcement for the second caller.
|
Press 2
|
Send caller to voice mail
|
Press 3
|
Send caller to another number
|
Press 7
|
Add caller to conference
|
TIP:
To transfer a call after you have connected to the caller, place the caller on hold (###) and press the appropriate key to transfer the call (2 for voice mail, 3 for another number, etc.).
|
Press 0
|
Send caller to your personal operator
|
To disconnect from a caller, press ***. You will remain in your account and can place calls, listen to messages, or perform any other account activity - without ever leaving your account.
Managing your Linx Account
Web Interface
|
|
